Console Modification; Appendixes - Planar Dome C2 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Configure Display Settings
Configure Windowing
DPMS Screen Saver

Console Modification

Dome CXtra Software

APPENDIXES

Troubleshooting
Specifications
Video Modes
Connector Ports
LED Status Lights
USB Connection
Console Modification
The console appears, by default, on the first head of the first board in the system's
probe list. You can change the console with the
variable. If you want to change the console without altering the probe list, change
the environment variable instead.
output-device
You can use the command to change environment variables.
setenv
To use the setenv command
1 Power on or halt the system to get to the ok> prompt.
2 Type:
setenv output-device <device node>
These examples describe how to change the console in Ultra™ 10 and
Ultra 30 systems. For more details, refer to your Sun documentation.
3 To make the DX board the console in an Ultra 10 system, type:
setenv output-device /pci/DOME,DxPCI
For an Ultra 30 system, which has two PCI buses, type:
setenv output-device /pci@X/DOME,DxPCI
where is the location of the board.
X
For example, if the board is installed at location
setenv output-device /pci@1f,4000/DOME,DxPCI
4 Reboot the system.
Dome CX Display System for Solaris
environment
pci-probe-list
, type:
1f,4000
Setenv command
The device node portion of the
setenv command differs for different
Sun systems and board locations.
23