Initial Installation - Honeywell Lynton 51852 User Manual

PREPARATION
Before beginning the assembly of this product, ensure all parts are present. Compare all parts with the package contents list
and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated assembly time: 2 hours
Tools required (not included): Phillips and Flat-head Screwdrivers, Safety Glasses, Step Ladder, Wire Cutter, and Wire Stripper.
1. Turn off power to the fan at the breaker box and the wall switch (Figure 1.1). DANGER: Failure to disconnect the power supply
prior to installation may result in serious injury or death.
2. Choose one of the following mounting options (Figure 1.2) :
Standard Mount - best suited for ceilings 8 feet or higher. For very high ceilings, use a longer downrod (not included).
Angle Mount - best suited for angled or vaulted ceilings. A longer downrod is sometimes necessary to ensure proper blade
clearance. Ensure the ceiling angle is not steeper than 10 degrees.
Flushmount Installation - not available for this model.
Closemount Installation - not available for this model.
3. Ensure the blades will be at least 30 inches from any obstructions. Also check the downrod length to ensure the blades will be
at least 7 feet above the floor (Figure 1.3).
Figure 1.1

INITIAL INSTALLATION

1. Loosen all four mounting bracket screws and completely remove the two screws from the round holes in the canopy. Then
remove mounting bracket from the canopy and save them for later. Remove the canopy from the mounting bracket (Figure 2.1).
2. Install the mounting bracket to the outlet box (sold separately) using the screws and washers provided with the outlet box.
WARNING: To reduce the risk of fire, electric shock, or personal injury, mount to the outlet box marked "acceptable for fan
support". (Figure 2.2).
3. Remove one of the three fitter plate screws preassembled to the fitter plate and loosen the other two but do not remove. Turn
shipping block counter clockwise and remove. Discard the shipping block, but save the fitter plate screw for later (Figure 2.3).
Canopy Mounting
Bracket Screw
Figure 2.1
Standard Mount
Flushmount
Figure 1.2
Angle Mount
D
Figure 2.2
EN I 5
Angle Mount
Closemount
Figure 1.3
Standard
Mount
D
Motor
Assembly
Shipping
Block
Figure 2.3
30 in.
minimum
7 feet
minimum
Fitter Plate
Fitter Plate Screw