Honeywell Lynton 51852 User Manual page 8

FINAL INSTALLATION
4. Align the holes of one blade with two blade screw holes in underside of the motor assembly. Secure with the two blade screws and
blade washers. Repeat this step for the remaining blades (Figure 5.4).
5. Feed the 9-pin connect through the center hole in the light pan. Align the keyhole slots in the light pan with the loosened
screws in the fitter plate. Turn light pan clockwise and replace the previously removed fitter plate screw. Tighten all screws
(Figure 5.5).
6. Remove one of the three light pan screws from the light pan and loosen the other two but do not remove. Connect the 9-pin
connector from the light pan to the 9-pin connector from the light kit. Lift the two keyhole slots in the light kit over the two
loosened light pan screws and turn in a clockwise direction. Then, use the previously removed light pan screw to secure the
light kit to the light pan. Tighten all screws (Figure 5.6).
7. Attach the glass bowl to the light kit by twisting the glass bowl firmly in a clockwise direction until it is secure.
CAUTION: Avoid cross-threading the glass during installation. Improper installation could cause the glass bowl to be difficult
to remove or fall, which could cause serious injury (Figure 5.7).
8. Remote control comes equipped with a wall bracket. If you wish to install the wall bracket, remove the small plate to expose
the screw holes. Insert wall brackets screws through holes and into wall, then cover with the previously removed small plate.
The remote can be stored in the wall bracket for easy access (Figure 5.8).
Turn on power to fan at breaker box and the wall switch. Assembly is complete.
Blade Washer
Blade Screw
Figure 5.4
Glass Bowl
Figure 5.7
Blade
Fitter Plate Screw
Figure 5.5
Small Plate
Wall Bracket
Screw
Figure 5.8
EN I 8
9-pin
Connector
Light Pan Light Kit
Light Pan Screw
Figure 5.6
Wall Bracket
9-pin
Connector
Keyhole
Slot