Installing The Canopy; Installing The Blades - Hunter 51736 Installation Manual

Place the receiver inside the
canopy. Ensure the wires
remain connected.
Partially install a canopy screw, found
in the hardware bag, between
the ceiling plate hooks. When all the
holes are properly aligned, securely
tighten all three canopy screws.
Ceiling Bracket Hanging Fan

Installing the Canopy

Swing the fan up to align the
canopy screw holes with the
mounting holes on the ceiling plate.
Note: The slots in the canopy
must remain engaged while
swinging the canopy for
alignment.
Ceiling Plate Hooks
Canopy
bag Screws

Installing the Blades:

Attach each blade to a blade iron using the blade washers, found in
the
hardware bag.
Repeat x4
Wiring
Hold the canopy up with the screw holes
aligned. Partially install two canopy screws,
found in the
holes opposite the ceiling plate hooks.
1 of 3
Using both hands, push the canopy trim
ring up to the top of the canopy. The canopy
trim ring will snap and lock into place.
Note: Should you need to remove the trim ring,
press firmly on opposite sides of the trim ring. The
tabs will flex out releasing the canopy trim ring.
hardware bag, and the blade assembly screws, found in the
Canopy Blades
bag
hardware bag, into the
WARNING
FAN FALL HAZARD
Make sure screws are tight.
bag
bag
Light Bulbs
1886
2 of 3
Canopy
Screws
x12
Blade Screw
x12
Blade Washer
6
Remote