Omron CS Series Operation Manual page 128

IP Addresses in FINS Communications
Using the ETN11-
compatible Mode
1,2,3...
Note
102
For Ethernet Unit with unit version 1.4 or later, operating specifications can be
made compatible with the CS1W-ETN11/CJ1W-ETN11 for all methods (auto-
matic generation (dynamic), I/O address table, or combined). (Dynamic
changes, however, are prohibited for the destination IP address in ETN11-
compatible mode.) While in ETN11-compatible mode, the following operations
will be performed the same as they are for the CS1W-ETN11/CJ1W-ETN11
for FINS/UDP command data sent from a UDP port number other than the
local FINS/UDP port number (default: 9600) set in the Unit Setup Tab Page.
• If the command data is for the Ethernet Unit, a FINS response will be sent
to the source UDP port number.
• If the command data is for any other Unit, such as the CPU Unit, a FINS
response will be sent to the UDP port number set as the FINS/UDP port
number.
The ETN11-compatible mode is set as follows using the Web function setting
window.
1. Connect to the Ethernet Unit from a Web browser and select Settings - 1.
IP address and Protocols - System. The System Format will be displayed.
2. Select ETN11 compatible mode from the FINS/UDP option in the System
Format, click the Set Button, click the Regist Button, and then turn the pow-
er supply OFF and ON or restart the Unit using a software restart.
(1) If the ETN11-compatible mode is used, internal method tables will not be
changed when the power supply is turned OFF and ON or software resets
are executed. This provides protection from access via FINS/UDP from
computers that dynamically change their IP address.
(2) The ETN11-compatible mode is not used for normal applications and
should not be used in most cases.
Section 5-2