Displayed Messages - DeLonghi ETAM36.36 Series Instructions For Use Manual

This appliance conforms to EC Regulation 1935/2004
on materials and articles intended to come into contact
with food.

17. DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A18) is full.
GROUND TOO FINE ADJUST
MILL
INSERT GROUNDS CONTAINER After cleaning, the grounds container (A18)
ADD PRE-GROUND COFFEE
DESCALE
REDUCE COFFEE AMOUNT
FILL BEANS CONTAINER
POSSIBLE CAUSE
Insufficient water in the tank (A7).
The grinding is too fine and the coffee is deli-
vered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
has not been replaced.
The pre-ground coffee function has been se-
lected without placing any pre-ground coffee
in the funnel (A4).
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
DISPOSAL
The appliance must not be disposed of with household
waste, but taken to an authorised waste separation and re-
cycling centre.
SOLUTION
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
Empty the grounds container and drip tray
(A16), clean and replace (fig. 28). Important:
when removing the drip tray, the grounds con-
tainer must be emptied, even if it contains few
grounds. If this is not done, when you make the
next coffees, the grounds container may fill up
more than expected and clog the machine.
Repeat coffee delivery and turn the grin-
ding adjustment dial (A6) (fig. 13) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section: "9.4 Adjusting the coffee mill").
Insert the hot water spout (C6) in the appliance
and deliver a little water until the flow beco-
mes regular.
Remove the drip tray (A16) and insert the
grounds container.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function (fig. 18).
The descaling procedure described in section
"13. Descaling" needs to be performed as soon
as possible.
Select a milder taste by pressing the
button (B1) (fig. 10) or reduce the quantity of
pre-ground coffee.
Fill the beans container (A2) (fig. 14).
Empty the funnel (A4) with the help of the
brush (C5) as described in section "12.8 Clea-
ning the pre-ground coffee funnel".
42