Basic Engine - MULTIQUIP Mikasa Series Operation And Parts Manual

Figure 3 shows the basic Yanmar engine. The engine must
be checked for proper lubrication and fi lled with fuel prior to
operation. Refer to the manufacturer's engine manual for
instructions and details of operation and servicing. Each
component is described below:
1. Fuel Filler Cap — Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. DO NOT over fi ll.
2. Fuel Tank — Capacity is 2.5 quarts (2.4 liters) of diesel
fuel.
DANGER
Adding fuel to the tank should be done
only when the engine is stopped and has
had an opportunity to cool down. In the
event of a fuel spill, DO NOT attempt to
start the engine until the fuel residue has
been completely wiped up and the area
surrounding the engine is dry.
3. Air Cleaner — Prevents dirt and other debris from
entering the fuel system. Remove wing-nut on top of
air fi lter canister to gain access to fi lter element.
NOTICE
Operating the engine without an air filter, with a
damaged air fi lter, or a fi lter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.
MVH150VD2 PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #0 (10/10/08) — PAGE 15
9
1
2
11
8
Figure 3. Compactor Components
10
5
7
6
4. Muffl er — Used to reduce noise and emissions.
WARNING
Engine components can generate extreme
heat. To prevent burns, DO NOT touch
these areas while the engine is running
or immediately after operating. NEVER
operate the engine with the muffler
removed.
5. Recoil Starting Handle (pull rope)
starting method.
6. Recoil Starter
starter grip until resistance is felt, then pull briskly and
smoothly.
7. Oil Filler Cap / Dipstick
to the engine crankcase. Read dipstick to determine if
oil level is low. DO NOT over fi ll.
8. Oil Drain Plug
crankcase. Dispose of oil in a safe manner.
9. Decompression Lever
engine. To prevent damage to engine, DO NOT use for
any other purpose.
10. Fuel Cock
carburetor. Must be in the ON position when starting
and running the engine.
11. Speed Control Lever

BASIC ENGINE

3
4
— Manual-starting method. Pull the
— Remove this cap to add oil
— Unscrew plug to drain oil from engine
— Press down before starting
— Controls the fl ow of diesel fuel to the
— Regulates engine speed.
— Type of engine