Basic Engine - MULTIQUIP Mikasa MVH502DSB Operation And Parts Manual

ENGINE COMPONENTS
Figure 4 illustrates the location of the major engine
components of the machine. Each component is described
below:
1. Fuel Filler Cap – Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tighten securely.
DO NOT over fill.
WARNING
Add fuel to the tank only when the engine is
stopped and has cooled down. In the event
of a fuel spill, DO NOT attempt to start the
engine until the fuel residue has been
completely wiped up and the area
surrounding the engine is dry.
2. Fuel Tank – Capacity is 1.85 gallons (7.0 liters) of #2
diesel fuel.
3. Air Cleaner – Prevents dirt and other debris from entering
the fuel system. Remove wing-nut on top of air filter
cannister to gain access to filter element.
NOTICE
Operating the engine without an air filter, with a damaged air
filter, or a filter in need of replacement will allow dirt to enter
the engine, causing rapid engine wear.
MVH502DSB/DSB2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #5 (03/11/11) — PAGE 15
Figure 4. MVH502DSB/DSB2 Engine Components
4. Muffler – Used to reduce noise and emissions.
WARNING
Engine components can generate extreme
heat. To prevent burns, DO NOT touch these
areas while the engine is running or
immediately after operating. NEVER operate
the engine with the muffler removed.
7. Oil Filler Cap/Dipstick – Remove this cap to add oil to the
oil tank. Use dipstick to check oil level.
8. Oil Drain Plug – Unscrew plug to drain oil from engine
crankcase. Dispose of oil in a safe manner.
9. Decompression Lever – Press down before starting
engine. To prevent damage to the engine, DO NOT use for
any other purpose.
10. Fuel Filter – Controls the flow of diesel fuel to the carburetor.
Must be in the ON position when starting and running the
engine.
11. Oil Filter – Filters oil for contaminates. Replace as
necessary.
12. Starting Handle Guide Sleeve – Insert starting handle
into the guide sleeve and turn to crank start engine.

BASIC ENGINE