MSI 880GMA-E35 Manual page 28

FSB/dRam Ratio
this item will allow you to adjust the ratio of FSB to memory.
adjusted dRam Frequency (mHz)
it shows the adjusted ddR memory frequency. Read-only.
Ht Link Control
Press <enter> to enter the sub-menu and the following screen appears.
Ht incoming/ outgoing Link Width
these items allow you to set the Hyper-transport Link width. Setting to [auto],
the system will detect the Ht link width automatically.
Ht Link Speed
this item allows you to set the Hyper-transport Link speed. Setting to [auto], the
system will detect the Ht link speed automatically.
adjusted Ht Link Frequency (mHz)
it shows the adjusted Ht Link frequency. Read-only.
adjust PCi-e Frequency (mHz)
this item allows you to adjust PCi-e frequency.
auto disable dRam/PCi Frequency
When set to [enabled], the system will remove (turn off) clocks from empty dimm
and PCi slots to minimize the electromagnetic interference (emi).
CPu Vdd Voltage (V), CPu-nB Vdd Voltage (V), dRam Voltage (V)
these items are used to adjust the voltage of CPu, memory and chipset.
Spread Spectrum
When the motherboard's clock generator pulses, the extreme values (spikes) of
the pulses create emi (electromagnetic interference). the Spread Spectrum func-
tion reduces the emi generated by modulating the pulses so that the spikes of
the pulses are reduced to flatter curves. if you do not have any emi problem,
leave the setting at disabled for optimal system stability and performance. But if
you are plagued by emi, set to enabled for emi reduction. Remember to disable
Spread Spectrum if you are overclocking because even a slight jitter can introduce
a temporary boost in clock speed which may just cause your overclocked proces-
sor to lock up.
imPoRtant
* if you do not have any emi problem, leave the setting at [disabled] for optimal
system stability and performance. But if you are plagued by emi, select the
value of Spread Spectrum for emi reduction.
the greater the Spread Spectrum value is, the greater the emi is reduced, and
*
the system will become less stable. For the most suitable Spread Spectrum
value, please consult your local emi regulation.
* Remember to disable Spread Spectrum if you are overclocking because even a
slight jitter can introduce a temporary boost in clock speed which may just cause
your overclocked processor to lock up.
MS-7641
27