Sync An Add-On Orbi Pro Satellite; Add Satellites To Your Network Using The Router Web Interface - NETGEAR Orbi Pro SRR60 User Manual

4. If the satellite ring LED is magenta, move the satellite closer to the router and then
sync the satellite to the router:
a. Press the Sync button on the back of the router.
b. Within two minutes, press the Sync button on the back of the satellite.
The satellite attempts to sync to the Orbi router. The satellite ring LED lights blue,
amber, or magenta as described in Step 3 of this procedure and then turns off.

Sync an Add-On Orbi Pro Satellite

If you already set up an Orbi Pro router and satellite are adding an optional add-on Orbi
Pro satellite (sold separately), follow these steps.
To sync your add-on Orbi Pro satellite:
1. Place your satellite.
For more information, see Place Your Satellite on page 17.
2. Connect the satellite to a power source.
3. If the Power LED on the back of the satellite does not light, press the Power On/Off
button.
4. Wait about two minutes for the satellite ring LED to light solid white.
5. Press the Sync button on the back of the satellite and within two minutes, press the
Sync button on the back of your Orbi router.
The satellite ring LED pulses white, then lights one of the following colors for about
three minutes, and then turns off:
• Blue. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is good.
• Amber. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is fair. Consider moving the Orbi satellite closer
to the Orbi router.
• Magenta. The Orbi router and satellite failed to sync. Move the satellite closer
to the router and try again.
Add Satellites to Your Network Using the Router Web
Interface
You can use the router web interface to add a satellite to your Orbi network.
Overview
Orbi Pro
18 User Manual