D-Link DIR-825 User Manual page 114

DIR-825 AC1200 Wave 2 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port
User Manual
Parameter
Hostname
Figure 89. Configuring the local interface. The IPv4 tab. The Dynamic IP Addresses section.
Parameter
Mode of dynamic IP
address assignment
Start IP
End IP
The name of the device assigned to its IP address in the local subnet.
Dynamic IP Addresses
An operating mode of the router's DHCP server.
Disable: The router's DHCP server is disabled, clients' IP
•
addresses are assigned manually.
DHCP server: The router assigns IP addresses to clients
•
automatically in accordance with the specified parameters.
When this value is selected, the Start IP, End IP, Lease
time fields and the DNS relay switch are displayed on the
tab. Also when this value is selected, the DHCP Options
and Static IP Addresses sections are displayed on the tab.
DHCP relay: An external DHCP server is used to assign IP
•
addresses to clients. When this value is selected, the
External DHCP server IP and Option 82 Remote ID
fields are displayed on the tab. Available if the Router,
WISP Repeater, or 3G/LTE modem mode was selected
in the Setup Wizard.
The start IP address of the address pool used by the DHCP server to
distribute IP addresses to clients.
The end IP address of the address pool used by the DHCP server to
distribute IP addresses to clients.
Page 114 of 249
Configuring via Web-based Interface
Description
Description