Maintenance And Service; Maintenance: Frequency And Tasks; Maintenance Tasks - Homeowner - Majestic fireplaces MDVI30IL Owner's Manual

4 4

Maintenance and Service

Any safety screen or guard removed for servicing must be
replaced prior to operating the fi replace.
When properly maintained, your fi replace will give you
many years of trouble-free service. Contact your dealer
to answer questions regarding proper operation, trouble-
shooting and service for your appliance. Visit www.ma-
jesticproducts.com to locate a dealer. We recommend
annual service by a qualifi ed service technician.
A. Maintenance: Frequency and Tasks
Task Frequency
Glass Cleaning Seasonally
Decorative
Annually
Front
Remote Control Seasonally
Venting Seasonally
Gasket Seal Annually
and Glass
Inspection
Log Inspection Annually
Firebox Annually
Inspection
Control Annually
Compartment &
fi rebox Top
Burner Ignition Annually
& Operation
B. Maintenance Tasks - Homeowner
Installation and repair should be done by a qualifi ed service
technician only. The appliance should be inspected before
use and at least annually by a professional service person.
The following tasks may be performed annually by the
homeowner. If you are uncomfortable performing any of
the listed tasks, please call your dealer for a service ap-
pointment.
More frequent cleaning may be required due to excessive
lint from carpeting, bedding material, et cetera. It is im-
perative that control compartments, burners and circulat-
ing air passageways of the appliance be kept clean. Any
safety screen, guard, or barrier removed for servicing the
appliance must be replaced prior to operating the appli-
ance.
CAUTION! Risk of Burns! The fi replace should be
turned off and cooled before servicing.
12 Majestic • MDVI30IN, MDVI35IN, MDVI30IL, MDVI35IL Owner's Manual • 2205-981 Rev. E • 11/16
To be completed by
Homeowner
Qualifi ed Service
Technician
Glass Cleaning
Frequency: Seasonally
By: Homeowner
Tools Needed: Protective gloves, glass cleaner, drop
cloth and a stable work surface.
CAUTION! Handle fi xed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• Avoid abrasive cleaners
• DO NOT clean glass while it is hot
• Prepare a work area large enough to accommodate fi xed
glass assembly and door frame by placing a drop cloth
on a fl at, stable surface.
Note: Fixed glass assembly and gasketing may have
residue that can stain carpeting or fl oor surfaces.
• Remove door or decorative front from fi replace and set
aside on work surface.
Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
•
The glass assembly fastens to the fi replace in four
places. Four of the fastening mechanisms are spring-
loaded glass latches. An example of the glass latch is
shown in Figure 4.1.
• To release glass assembly, pull the two bottom
spring-loaded latches forward and allow them to
retract away from the glass assembly. Slide the glass
assembly outward and downward until the top latches
disengage.
• Clean glass with a non-abrasive commercially available
cleaner.
- Light deposits: Use a soft cloth with soap and water
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer)