Toshiba RAS-13S3KV-E Service Manual page 90

No. Part name
ƒ
Horizontal louver
„
Evaporator
(Heat exchanger)
Procedures
1) Remove shaft of the horizontal
louver from the back body.
(First remove the left shaft, and
then remove other shafts while
sliding the horizontal louver
leftward.)
1) Follow to the procedure in the item
2) Remove the pipe holder from the rear side of the main unit.
3) Remove two fixing screws at the left side of the end plate of the heat exchanger.
2 screws
4) Remove one fixing screw on the
heat exchage fixing holder to separate the
heat exchage from the back body.
5) Remove right side of the end plate from
two fixing rib while sliding slightly the
heat exchanger rightward.
ƒ
.
– 89 –
FILE NO. SVM-15008
Remarks
Heat exchanger fixing
holder
Rib on the right side of the end plate
Screw