Table of Contents
Advertisement
k
Move the print head, and then remove any material
remaining in this area. Make sure pieces of material
are not left in the corners of the machine (1) and
(2).
1
IMPORTANT
• If the print head is in the right corner as shown in the
illustration, you cannot move the print head. Close the top
cover, and then reconnect the power cord. Open the top
cover again and then hold down
moves to the center. Then unplug the machine from the
power source and remove the material.
• If the material is jammed under the print head, unplug the
machine from the power source, and then move the print
head to remove the material.
• If ink gets on your skin or clothing, immediately wash it off
with soap or detergent.
l
Gently close the top cover using the finger holds on
each side.
19
m
2
n
o
until the print head
p
q
r
s
Pull Tray #2 completely out of the machine as
shown by the arrow.
Remove the Fabric Roll from Tray #2 and roll up
the fabric.
If the feeding edge is folded, bent, or cut at an angle, cut it
straight across.
Reload the Fabric Roll into Tray #2.
For details on loading, refer to "Load the Fabric Roll in
Tray #2" (P.8).
Close the upper Jam Clear Cover A at the back of
the machine. Make sure the cover is closed
completely.
Put the paper support firmly back in the machine.
Make sure you fit the paper support into the
channel.
Slowly push the paper trays completely into the
machine.
Reconnect the power cord.
Advertisement
Table of Contents
