EN 14
4.
EM5E-DVD
4. Mechanical instructions
4.1
Service Positions
The following PWB's or modules are added for DVD (see also
PWB location drawing):
1. DVD Interface panel.
2. DVD Module.
4.1.1
DVD Interface Panel
•
For better accessibility of the panel, remove the complete
PWB from its bracket. Therefore release the two clamps at
the side of the bracket [1] and lift the panel out [2], (see
figure "DVD interface board"). (For measuring safely when
the LSP is in service position, remove the bracket from the
bottom tray by pulling it backward while lifting the clamp [3].
Then pull it upward [4], and replace the panel into the
bracket.)
3
4
Figure 4-1 DVD interface board.
4.1.2
DVD Module
•
Remove the cables from connectors 1501, 1600, 1603 and
1604 on the DVD module.
•
Remove the DVD lock plate [1]. Therefore lift the two
clamps [2] (see Figure "DVD lock plate removal") and pull
back the lock plate.
•
Remove the DVD-interface module from the bottom tray.
Therefore lift the backside of the module and pull the
module backwards, (see figures hereunder).
Mechanical instructions
1
2
CL 06532140_012.eps
021100
1
Figure 4-2 DVD lock plate removal.
Figure 4-3 Release DVD module.
4.1.3
DVD Board
•
Press the DVD-tray release catch [1] and slide the DVD
tray forward, (see figure "DVD-tray release catch."). Be
sure to push it in far enough, a screwdriver might be
needed.
•
Unscrew four fixation screws [1], and remove the screws,
(see figure "DVD fixation screws").
•
Remove 2 fixation screws, on metal bottom cover.
•
Un-twist the three lugs and take off the metal cover. The
DVD board can now be accessed.
2
CL 26532086_023.eps
050702
CL 26532086_024.eps
050702