Table of Contents
Advertisement
R
CAUTION
Disengage power to the mower before backing
up. Do not mow in reverse unless absolutely
necessary and then only after observation of the
entire area behind the mower.
CAUTION
Before backing up, observe behind the mower for
persons and obstructions. Clear the area before
backing up. Possible injury or property damage
could occur.
- NOTE -
A squealing noise may be heard when engaging
or disengaging the deck drive. It is caused by the
electric clutch plates meshing as the mower comes
up to speed. This is normal.
3.
To disengage the deck drive, push the switch in to the
disengage position.
4.
Always operate the engine at full throttle to properly maintain
cutting speed. If the engine starts to lug down, reduce the
forward speed and allow the engine to operate at maximum
RPM.
4.9 HILLSIDE OPERATION
WARNING
DO NOT operate on steep slopes. Under no
circumstances should the machine be operated
on slopes greater than 20 degrees. See Figure 2-1,
Page 6 to determine approximate slope of area to
be mowed. ALWAYS FOLLOW OSHA APPROVED
OPERATION.
1. This mower has been designed for good traction and
stability under normal mowing conditions. However,
caution must be used when traveling on slopes,
especially when the grass is wet. Wet grass reduces
traction and steering control.
2.
Stay at least 2 cutting widths away from drop-offs, ditches,
retaining walls, water, avoid any slope exceeding 20-degrees.
3.
To prevent tipping or loss of control, do not start or stop
suddenly, avoid unnecessary turns and travel at reduced speed.
If tires lose traction, disengage blades and proceed slowly off
the slope.
4.
Avoid sudden starts when mowing uphill. Sudden starts may
cause the machine to tip backwards.
5.
Loss of traction may occur when traveling down hill. Weight
transfers to the front of the machine and may cause the drive
wheels to slip causing loss of braking or steering.
6.
Never back down a hill.
7.
Keep tires properly inflated.
4.10 PARKING THE MOWER
1. Park the machine on a flat, level surface only. Do not
park the machine on an incline.
2.
Place the steering control levers in the neutral position.
3.
Disengage the cutter blades.
4.
Slow the engine to idle speed.
5.
Engage the parking brake.
6.
Turn the ignition key to the OFF position and remove the key.
4.11 AFTER OPERATION
1. Wash the entire mower after each use. Do not
use high pressure spray or direct the spray onto
electrical components.
- IMPORTANT -
Do not wash a hot or running engine. Cold water
will damage the engine. Use compressed air to
clean the engine if it is hot.
2.
Keep the entire mower clean to inhibit serious heat damage to
the engine or hydraulic oil circuit.
3.
Check the drive belts for proper alignment and any signs of
wear. Correct and adjust if necessary.
20
Section 4
Advertisement
Table of Contents
