Display Assembly; Removing The Display Assembly - Dell P112F Service Manual

Steps
1. Using the alignment posts, place the power button with fingerprint reader into its slot on the palmrest and keyboard
assembly.
2. Replace the (M2x2) screw that secures the power button with fingerprint reader to the palmrest and keyboard assembly.
3. Adhere the fingerprint reader Flexible Flat cable to the palmrest and keyboard assembly
NOTE: Fold and align the fingerprint reader Flexible Flat cable to the mark at the right of the power button, and align
the white line on the Flexible Flat cable to the mark on the palmrest and keyboard assembly.
4. Close the display hinge.
5. Replace the two (M2.5x5) screws that secure the display hinge to the palmrest and keyboard assembly.
Next steps
1. Install the I/O board.
2. Install the base cover.
3. Install the SD card.
4. Follow the procedure in

Display assembly

Removing the display assembly

CAUTION: The maximum operating angle for the display-panel hinge is 135 degrees.
Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the Wireless
48 Removing and installing components
After working inside your
Before working inside your
card.
computer.
computer.
\