Display Assembly - Dell XPS L502X Service Manual

Back to Contents Page
Display
Dell™ XPS™ L502X Service Manual
Display Assembly
Display Bezel
Display Panel
Display Cable
Display-Panel Brackets
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the module cover (see
4. Remove the memory module(s) (see
5. Disconnect the antenna cables from the Mini-Cards.
6. Note the routing of the Mini-Card antenna cables and remove them from the routing guides on base cover.
7. Remove the two screws that secure the display assembly to the base cover.
1 antenna cables
CAUTION: Be extremely careful when opening the display to prevent damaging the display assembly.
8. Remove the palm-rest assembly (see
Begin.
Battery).
Removing the Module Cover).
Removing the Memory Module(s)).
2 base cover
Removing the Palm-Rest Assembly).
Removing the Battery) before working inside the