Igloo ICF18 Operating Manual page 22

Operation
I
NOTE
When latching the lid, ensure that both latch side pins are fully engaged
to ensure a good lid seal. One latch may engage slightly before the
other.
If the lid is not closed equally at both sides, press until a second click is
heard.
5.6 Setting the temperature
1. Press the "SET" button (fig. 3 , page 5) once.
2. Use the "UP +" (fig. 3 , page 5) and "DOWN –" (fig. 3 , page 5) buttons to
select the cooling temperature.
✔ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
5.7 Setting the display brightness
The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
1. Switch on the cooler.
2. Press the "SET" button (fig. 3 , page 5):
– Four times.
3. Use the "UP +" (fig. 3 , page 5) or "DOWN –" (fig. 3 , page 5) buttons to set
the brightness of the display.
✔ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✔ The display shows the set mode for several seconds. The display flashes twice
before it returns to the current temperature.
I
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically reverts to brightness d0
(default). After troubleshooting the set brightness is reactivated.
5.8 Switching off the cooler
1. Empty the cooler.
2. Switch the cooler off.
3. Pull out the connection cable.
22
ICF18, ICF32, ICF40, ICF60, ICF80DZ
EN