Igloo ICF18 Operating Manual page 21

ICF18, ICF32, ICF40, ICF60, ICF80DZ
5.5 Using the cooler
A
NOTICE! Overheating hazard
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
1. Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate. We recommend keeping a gap of at least 50 mm around ventilation
holes.
A
NOTICE! Damage hazard
Place the cooler as shown (fig. 1, page 3). If you operate the cooler in
a different orientation it can be damaged.
2. Connect the cooler (see chapter "Connecting the cooler" on page 17).
A
NOTICE! Excessively low temperature hazard
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
3. Press the "ON/OFF" button (fig. 3 , page 5) for between one and two
seconds.
✔ The LED "P" lights up (fig. 3 , page 5).
✔ The display (fig. 3 , page 5) switches on and shows the current temperature.
✔ The cooler starts cooling the interior.
I
NOTE
When operating from a battery, the display switches off automatically if
the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
1. Close the lid.
2. Press the latch (fig. 2, page 4) down, until it latches in place audibly.
EN
Operation
21