Igloo ICF18 Operating Manual page 12

Safety instructions
• Opening the cooling device for long periods of time can cause signif-
icant increase of the temperature in the compartments of the device.
• Clean regularly surfaces that can come in contact with food and
accessible drainage systems.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mold developing within the device.
A
NOTICE! Damage hazard
• Check that the voltage specification on the data plate corresponds to
that of the energy supply.
• Only connect the cooling device as follows:
– With the DC connection cable to a DC power supply in the vehicle
– Or with the AC connection cable to an AC power supply
• Connect the cooling device to an AC power supply with the AC con-
nection cable.
• Never pull the plug out of the socket by the cable.
• If the cooling device is connected to a DC outlet, disconnect the
cooling device and other power consuming devices from the battery
before connecting a quick charging device.
• If the cooling device is connected to a DC outlet, disconnect the
cooling device or switch it off when turning off the engine. Otherwise
the battery may be discharged.
• The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
• The insulation of the cooling device contains flammable cyclopentane
and requires special disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate recycling center.
• Do not place the cooling device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
• Risk of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation on all
sides of the cooling device. Keep the ventilation area free of any
objects that could obstruct the air flow to the cooling components.
Do not use or store the cooling device in closed compartments or
areas with none or minimal air flow.
• Do not fill the inner container with ice or fluids.
12
ICF18, ICF32, ICF40, ICF60, ICF80DZ
EN