Advertisement
and disinfection..Please take out the internal battery before cleaning and disinfection.
% The product is suitable for adults.
% The device may not be suitable for all users, if you can't get a satisfactory result,
please stop using it.
% Data averaging and signal processing have a delay in the upgrade of SpO
When the data update period is less than 30 seconds, the time for obtaining dynamic
average values will increase, which is arisen from signal degradation, low perfusion or
other interference, it depends on the PR value.
% The device has 3-year service life, date of manufacture: see the label.
% The device hasn't low-voltage prompt function, it only shows the low-voltage,
please change the battery when the battery voltage is used up.
% The maximum temperature at the SpO
41℃ which is measured by the temperature tester.
% During measuring, when abnormal conditions appear on the screen, please pull out
your finger and reinsert it to measure again.
% If some unknown error appears during measuring, remove the battery to terminate
operating.
% Do not contort or drag the wire of the device.
% The plethysmographic waveform is not normalized, as a signal inadequacy indicator,
when it is not smooth and stable, the accuracy of the measured value may degrade.
When it tends to be smooth and stable, the measured value read is the optimal and
the waveform at this time is also the most standard.
% If the device or component is intended for single-use, then the repeated use of these
8
probe -tissue interface should be less than
2
data values.
2
Advertisement
