Advertisement
5. Operating Guide
Insert the two batteries properly to the direction, and then replace the cover.
1)
Open the clip as shown in Figure 5.
2)
Let the patient's finger put into the rubber cushions of the clip (make sure the fin-
3)
ger is in the right position), and then clip the finger.
Press the button once on front panel.
4)
Do not shake the finger and keep the patient at ease during the process. Meanwhile,
5)
human body is not recommended in movement status.
Get the information directly from screen display.
6)
When the device is in operation status, the display mode can be changed.
When the device is in standby mode, pressing the button can exit it; When the device
7)
is in operation status, pressing the button long can change brightness of the screen.
8)
Under non-measurement state, it will enter standby mode automatically when there
is no operation within 5s.
Fingernails and the luminescent tube should be on the same side.
Figure 5 Put finger in position
15
Advertisement
