Table of Contents
Advertisement
6-10 Checking the Airfl ow
Checking Airfl ow
1. Make sure there are no objects to obstruct airfl ow in and out of the server. In
addition, if you are using a front bezel, make sure the bezel's fi lter is replaced
periodically.
2. Do not operate the server without drive carriers and either a drive or dummy
drive in the carrier. Use only recommended server parts.
3. Make sure no wires or foreign objects obstruct airfl ow through the chassis.
Pull all excess cabling out of the airfl ow path or use shorter cables.
4. The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons.
Installation Complete
In most cases, the chassis power supply and fans are pre-installed. If you need
to install fans or power supplies, continue to the Systems Fan and Power Supply
sections of this chapter. If the chassis will be installed into a rack, continue to the
next chapter for rack installation instructions.
Chapter 6: Advanced Chassis Setup
6-17
Advertisement
Table of Contents
