Volvo S90 2019 Owner's Manual page 155

Using main beam
Main beam is operated with the left-hand stalk
switch. Main beam is the car's strongest lighting
and should be used when driving in the dark for
better visibility, as long as it does not dazzle
other road users.
Steering wheel stalk switch with rotating ring.
Main beam flash
Move the stalk switch backwards slightly to
main beam flash position. Main beam comes
on until the stalk switch is released.
Main beam
Main beam can be activated when the steer-
ing wheel stalk switch's rotating ring is in
5
position or . Activate main
beam by moving the stalk switch forwards.
When dipped beam is activated.
5
Deactivate by moving the stalk switch back-
wards.
When main beam has been activated the
symbol illuminates in the driver display.
Related information
Lighting control (p. 148)
•
Active main beam (p. 153)
•
Replacing the main beam lamp (p. 611)
•
Active main beam
Active main beam is a function which uses a
camera sensor at the top edge of the wind-
screen to detect the headlamp beams from
oncoming traffic or the rear lights of vehicles in
front, and then switches from main beam to
dipped beam.
Active main beam is activated with the rotating ring on
the stalk switch in position .
The function can also take streetlights into
account. Main beam is reactivated when the cam-
era sensor no longer sees any oncoming vehicles
or vehicles ahead.
The function can start while driving in the dark
when the car's speed is approx. 20 km/h (approx.
12 mph) or higher.
LIGHTING
}}
153