AT&T BL102 Quick Start Manual page 19

Bluetooth®
Notes:
Your BL102/BL102-2/BL102-3/BL102-4/BL102-5 is compatible with Bluetooth version 2.0 or above
f
devices.
Before you begin, make sure that you have cellular coverage and your Bluetooth enabled cell
f
phone is not connected to any other Bluetooth device.
Make sure you turn on the Bluetooth feature of your cell phone. Refer to your cell phone user's
f
manual to learn how.
Pair your cell phone and download the phonebook:
1. Place your cell phone next to the telephone base.
2. Press and hold
will beep once, then shows Pb on the display. It enters pairing mode.
After your cell phone finds your AT&T telephone system (AT&T DECT 6.0),
f
press the appropriate key on your cell phone to continue the pairing process.
Once paired, your cell phone may request for the permission of allowing the
f
telephone system (AT&T DECT 6.0) to access your cell's phonebook.
3. Permit the request if you wish to continue.
The telephone starts
f
downloading, and the base's
display animates.
Note: The process may take around
30 minutes, depending on the
number of your cell phone
phonebook's entries.
4. When the download completes, the base plays a confirmation tone, and its
display returns to idle. The base will disconnect from the cell phone.
Cancel the download
You can cancel the download by pressing X/DELETE on the base.
Ì
Restart the download
When error occurs during downloading, the base plays an error tone with 4
beeps. Its display shows Er for 5 seconds, then it returns to idle.
To restart the download:
Repeat the process from step 1.
Ì
Note: The telephone system will remove any duplicate entries, and any entries that contain
unrecognizable symbols; therefore, the number of entries downloaded from your cell phone
phonebook may be less than the number of entries stored in your cell phone.
/REPEAT on the base for at least 4 seconds. The base
17
Pb
Er