Advertisement
T
A
OTAL
CCESS
Feature
IP Address
User Name
Password
HTTP Server
Event History
IP Routing
R
F
ESTORING
ACTORY
On units that have a console port, you cannot restore the factory defaults, but must rather erase the device's
configuration and then reconfigure the unit to operate correctly for your network. To erase the unit's current
configuration, follow these steps:
1.
Access the unit's CLI and enter enable at the > prompt.
2.
Enter erase startup-config at the # prompt. The device will have a blank configuration upon reboot.
3.
Enter reload at the # prompt to begin restarting the device. When prompted to save configuration, enter
no. When prompted to reboot, enter yes.
4.
Upon reboot, you will have to reconfigure the unit using the CONSOLE port. Follow the steps outlined
here or in the technical note, Accessing the Web Interface in AOS, available online at
(article number 1788).
V
C
OICE
ONNECTION
A single 50-pin female amphenol connector provides the interconnect wiring for the analog circuits (FXS). Refer
to the Total Access 900e Series Hardware Installation Guide provided on the AOS Documentation CD or
available online at
http://kb.adtran.com
B
B
ATTERY
ACKUP
An optional battery backup system (P/N 1175044L1/L2) is available for the Total Access 900e Series. Refer to
the Total Access 900e Series Hardware Installation Guide provided on the AOS Documentation CD or available
online at
http://kb.adtran.com
system for more information on this connection.
4
900
S
D
E
ERIES
D
EFAULTS
(article number 3398) for detailed pinouts.
C
ONNECTION
(article number 3398) and to the documentation shipped with the battery backup
Copyright © 2010 ADTRAN, Inc. All Rights Reserved.
EFAULTS
Default Value
10.10.10.1
admin
password
Enabled
On
Enabled
http://kb.adtran.com
Advertisement
