Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark Cordless Pro IZ531H Owner's Manual

MAINTAINING YOUR VACUUM

EMPTYING THE DUST CUP

Press the wand release button to disconnect the
handheld vacuum from the wand.
REMOVING AND CLEANING THE DUST CUP
To remove the dust cup from the handheld vacuum,
press the CleanTouch™ Dust Cup Release button near
the handheld vacuum nozzle. Tilt the dust cup and lift
off to remove.
To empty dust and debris, hold the dust cup over the
trash, then slide the CleanTouch Dirt Ejector slider
forward.
s h a r kc l e a n . c o m
1
To empty the Dust Cup while it is attached to the
handheld vacuum, position the dust cup over a trash
receptacle and slide the CleanTouch™ Dust Cup
Release slider forward.
1
To clean the interior of the dust cup, rinse it with
water. Place it on its side with the lid open to air-dry
for at least 24 hours before reinstalling.
Regularly rinse and replace the filters to maintain your vacuum's suction power.
2
To clean filters, rinse them with water only. Allow all filters to air-dry completely before reinstalling to
prevent liquid from being drawn into electric parts.
Clean the pre-motor filters at least once a month and post-motor HEPA filter at least once a year. Tap off loose
dirt between washes when needed. More frequent cleaning may sometimes be necessary with heavy use.
IMPORTANT: DO NOT use soap when cleaning the filters. Use water only. The vacuum will not have suction if the post-motor
HEPA filter is not installed. Ensure that all filters are installed before using.
PRE-MOTOR FILTER
Remove the dust cup, and pull the foam and felt
filters out of the back of the dust cup.
2
Pre-Motor Foam and Felt Filter Kit
MAINTAINING YOUR VACUUM

CLEANING THE FILTERS

POST-MOTOR FILTER
Remove the dust cup. Pull the post-motor filter out
of the handheld vacuum.
Post-Motor HEPA Filter
sharkclean.com