Safety And Instruction Decals; Assembly; Unpacking The Mower; Assembling The Handle - Toro Recycler 20022 Operator's Manual

Walk-behind power mower
Table of Contents

Advertisement

Safety and Instruction Decals

Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
ON REAR HEIGHT ADJUSTER
ON MOWER HOUSING
(Part No. 43–8480)

Assembly

IMPORTANT: Be extremely careful when unpacking
and handling the mower and upper handle so that you
do not pull, crimp, or in any way damage the cables.

Unpacking the Mower

1. Open the box from the top.
2. Remove the lower handle from the box (models
20023, 20025, 20027, and 20061 only).
3. Remove the fillers from the box, allowing the upper
handle to rest on the top of the mower.
4. Remove the mower from the box.
5. Lay the upper handle on the ground behind the mower
with the handle label facing up and the control cables
routed between the handle mounting brackets (Fig. 1).

Assembling the Handle

Models 20023, 20025, 20027, and 20061
1. Squeeze the lower handle section ends together,
position the holes in the handles over the pins on the
handle brackets, and release the handle (Fig. 1).
IMPORTANT: The cables must be routed inside of the
lower handle and the starter rope outside the handle.
(Part No. 92–2914 Right)
(Part No. 92–2915 Left)
ON MOWER HOUSING
(Part No. 93–0248)
2
4
1. Cable
2. Starter rope
All Models
1. Remove the four handle bolts and knobs that are
installed in the lower handle (two bolts will have flat
caps and two will be contoured to fit the handle).
2. Swing the lower handle back and the support brackets
up, aligning the brackets with the holes in the handle
(Fig. 2).
3. Secure the handle to the support brackets with the two
flat handle bolts and two knobs, using the height
adjustment holes on the brackets that best suit your
height requirements (Fig. 2)
1
4
2
1. Lower handle
2. Support bracket
5
ON MOWER HOUSING
(Part No. 99–6018)
3
4
1
m–4215
Figure 1
3. Lower handle section
4. Pins
3
m–4208
Figure 2
3. Knob
4. Flat handle bolt

Advertisement

Table of Contents
loading

Table of Contents