Toro Recycler 20022 Operator's Manual page 19

2. Remove the knob and side cover clamp (Fig. 31).
Figure 31
1. Knob
2. Side cover clamp
3. Remove and save the three bolts securing the
discharge cover to the mower (Fig. 32). Save the cover
and bolts for future use.
2
Figure 32
1. Discharge cover
2. Bolt (3)
4. Remove the screw and nut from side of the mower
(Fig. 32). Save them for future use.
5. Install four grommets supplied with the grass catcher
into the four square holes in the mower (Fig. 33).
1
Figure 33
1. Grommet (4)
6. Insert the tongue of the discharge tunnel into the
mower (Fig. 34).
7. Align the holes in the tunnel with the grommets in the
mower (Fig. 34).
8. Ensure that the hole in the tongue aligns with the hole
in the side of the mower (Fig. 34).
1
2
3
m–4275
3. Side opening cover
3
1
m–4275
3. Screw and nut
2009
5
4
1. Discharge tunnel
2. Tongue
3. Self-tapping screw
9. Install the self-tapping plastite screw supplied with the
grass catcher into the side hole and tongue, and
partially tighten the screw (Fig. 34).
10. Using three screws supplied with the grass catcher,
fasten the discharge tunnel to the mower (Fig. 34).
11. Secure the front, right corner of the discharge tunnel
and the side opening cover with the side cover clamp
removed previously and the long knob supplied with
the grass catcher (Fig. 35)
1. Long knob
2. Side cover clamp
DANGER
POTENTIAL HAZARD
If the side opening cover is not securely
clamped in place, debris could be thrown out of
the side opening.
WHAT CAN HAPPEN
Thrown debris can cause serious personal
injury or death to the operator or bystanders.
HOW TO AVOID THE HAZARD
Always ensure that either the side opening
cover is closed and locked in place by the side
cover clamp or that the side discharge chute is
securely seated in place before starting the lawn
mower.
19
4
1
3
2010
2
Figure 34
4. Bolt (3)
5. Discharge tunnel door
1
2
3
m–4274
Figure 35
3. Side opening cover