Connecting The Server To The Mains - Fujitsu PRIMERGY TX1330 M3 Operating Manual

Two additional USB connectors (2x USB 3.0) are located on the front of the
server (see figure 7 on page
Connecting the monitor
Ê Connect the monitor to the video connector of the server (see
page 52).
Ê Connect the power cable of the monitor to a grounded mains outlet of the in-
house mains and/or to the mains socket strip of the rack.
V
CAUTION!
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
5.5

Connecting the server to the mains

The server is equipped with an integrated PSU.
V
CAUTION!
The server is automatically set to a mains voltage in the range 100 V -
240 V. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Ê Connect the power cord to the server PSU.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network or a power outlet of the socket strip in the rack (see Technical
Manual for rack).
TX1330 M3
62).
Operating Manual
Hardware installation
figure 2 on
53