Table of Contents
Advertisement
DIAL AND BUTTONS
INTRODUCTION
The options/functions are not available
with all washing programmes. Check
the compatibility between options/
functions and washing programmes in
the "Programme Chart". An option/
function can exclude another one, in
this case the appliance doesn't allow
you to set incompatible options/
functions.
ON/OFF
Press this button for a few seconds to activate or
deactivate the appliance. Two different tunes sound
while switching the appliance on or off.
As the Stand-by function automatically deactivates
the appliance after several minutes to reduce the
energy consumption, you may need to activate the
appliance again.
For more details, refer to Stand-by paragraph in
Daily Use chapter.
TEMP.
When you select a washing programme, the
appliance automatically proposes a default
temperature.
Touch this button repeatedly until the desired
temperature value appears on the display.
When the display shows the indicators
appliance does not heat the water.
SPIN
When you set a programme, the appliance
automatically sets the maximum spin speed
allowed, except for programme Denim. With this
option you can decrease the default spin speed.
Touch repeatedly this button to:
•
Decrease the spin speed. The display shows
only the spin speeds available for the set
programme.
•
Additional spin options No Spin
Set this option to deactivate all spin phases.
The display shows the indicator
appliance performs the only draining phase of
the selected washing programme. Set this
option for very delicate fabrics. The rinses phase
uses more water for some washing programmes
•
Activate the Rinse Hold
The final spin is not performed. The water of the
last rinse is not drained out to prevent the
, the
.
. The
option.
fabrics from creasing. The washing programme
ends with water in the drum.
The indicator
locked and the drum turns regularly to reduce
creasing. You must drain the water to unlock the
door.
If you touch the Start/Pause
appliance performs the spinning phase and
drains the water.
The appliance empties the water
out automatically after 18 hours
approximately.
PREWASH
With this option you can add a prewash phase to a
washing programme.
The corresponding indicator above the touch
button illuminates.
•
Use this option to add a pre-wash phase at 30
°C before the washing phase.
This option is recommended for heavily soiled
laundry, especially if containing sand, dust, mud
and other solid particles.
The options can increase the
programme duration.
STAIN
Touch this button to add the stain phase to a
programme.
The corresponding indicator above the touch
button illuminates.
Use this option for laundry with hard stains to
remove.
When you set this option, put the stain remover into
compartment
.
The stain remover is pre-mixed and heated with
detergent in order to improve its effectiveness.
This option increases the programme
duration.
This option is not available with a
temperature lower than 40 °C.
PERMANENT EXTRA RINSE
With this option you can add a few rinses
according to the selected washing programme.
Use this option for people with allergies to
detergent residues and with sensitive skin.
remains on. The door stays
button, the
11
Advertisement
Table of Contents
