Basic Operations; Turn On The Power; Select The Source To Play - JVC RX-D302BC Instructions Manual

Basic operations

1
Source lamps
1
4
7
10
1

Turn on the power

Press STANDBY/ON (or
remote control).
The standby lamp goes off and the source lamp of the current
source lights in red.
Current source name appears.
ANALOG
AUTO SURR
L R
S.WFR
To turn off the power (into standby)
Press STANDBY/ON (or
again.
The standby lamp lights in red.
NOTE
A small amount of power is consumed in standby mode. To turn
the power off completely, unplug the AC power cord.
14
3
2
1
2
3
2 3
5 6
8 9
0 10
AUDIO on the
TUNED STEREO AUTO MUTING
MHz
AUDIO on the remote control)
2

Select the source to play

On the front panel:
Turn SOURCE SELECTOR until the source name
you want appears on the display.
The source lamp corresponding to the selected source lights in
red.
• As you turn SOURCE SELECTOR, the source changes as
follows:
ANALOG
AUTO SURR TUNED STEREO AUTO MUTING
L R
S.WFR
DVD MULTI DVR/DVD (DGTL)
VCR (DIGITAL)
DBS (DIGITAL)
TV (DIGITAL)
USB WIRELESS
USB TERMINAL FM
(Back to the beginning)
DVD MULTI: Select the DVD player using the analog
discrete output mode (5.1-channel
reproduction).
DVR/DVD (DGTL) * : Select the DVD recorder or DVD player.
VCR (DIGITAL) * : Select the VCR.
DBS (DIGITAL) * : Select the DBS tuner.
TV (DIGITAL) * : Select the TV.
USB WIRELESS: Select the PC component using a
wireless equipment.
USB TERMINAL: Select the PC component.
FM: Select an FM broadcast.
AM: Select an AM broadcast.
From the remote control:
Press one of the source selecting buttons.
• For USB WIRELESS and USB TERMINAL, press USB. Each
time you press USB, the mode alternates between USB
WIRELESS and USB TERMINAL.
* Selecting the analog or digital input mode
You need to select the proper input mode according to the
connection method (analog or digital) on pages 7 to 11.
• In case of digital connection, you also need to select the correct
digital input terminal. (See "Setting the digital input (DIGITAL IN)
terminals—DIGITAL IN 1/2/3" on page 22.)
From the remote control ONLY:
Press ANALOG/DIGITAL to select the analog or
digital input mode.
• Each time you press the button, the input mode alternates
between the analog input ("ANALOG") and the digital input
("DGTL AUTO"). This setting is memorized for each source.
DGTL AUTO (DIGITAL AUTO):
Select for the digital input mode. The
receiver automatically detects the
incoming signal format, then the digital
signal format indicator (LINEAR PCM,
detected signal lights up.
ANALOG: Select for the analog input mode. The
ANALOG indicator lights up on the
display.
Initial setting: DGTL AUTO
NOTES
• You cannot select the digital input mode when selecting "DVD
MULTI," "FM," or "AM" as the source.
• The input mode is fixed to "DGTL AUTO" when selecting "USB
WIRELESS" or "USB TERMINAL" as the source.
MHz
AM
, , or 96/24) for the