Rear View - Watchguard XTM 3 Series Hardware Manual

Dual USB interface
Connect a USB storage device to use for USB backup and restore, or to store a support snapshot.
For more information about USB functions, see the Fireware XTM WatchGuard System Manager Help
or Fireware XTM Web UI Help.
Network Interfaces
The interfaces have standard RJ45 connectors and are labeled 0,1,2,3,4,5,6. All interfaces support link
speeds of 10, 100, or 1000 Mbps.
Indicators for network interfaces
At the top of each labeled network interface, there is a pair of indicators. The indicator at the left of
the interface is the activity indicator for that interface. The indicator at the right shows the connection
speed for that interface.
Indicator
Activity (upper left)
Connection Speed
(upper right)

Rear View

The AC receptacle, fan, and power switch are on the rear of the device.
AC receptacle
Accepts a detachable AC power cord supplied with the device. The power supply for the device is a
WatchGuard standard auto-sensing AC power supply.
Fan
The fan decreases the internal temperature of the device.
Power switch
Controls the power supplied to the device.
Caution
Hardware Guide
Indicator color
Yellow
Not lit
Blinks
(speed of blink increases as the
data flow increases)
Not lit
Green
Yellow
You must disconnect the power supply before you remove the cover of the XTM 3 Series
device. If you open the cover without prior authorization from WatchGuard, this voids the
Hardware Warranty.
Hardware Specifications
Interface Status
Power on, connection established
Power off, no connections
Data sent and received
Link speed: 10 Mbps
Link speed: 100 Mbps
Link speed: 1000 Mbps
5