Table of Contents
Advertisement
Split Pointer
The split pointer is marked on the v Mode Disk. Whenever you enter the Stopwatch
Split Mode (page E-63), it indicates the current status of the stopwatch operation.
While a normal stopwatch elapsed time measurement operation is in progress, the
split pointer will point to RUN. When a split time is indicated by the hands (which are
temporarily stopped), the split pointer will point to SPL. Stopping the elapsed time
measurement operation will cause the split pointer to move to STP (stop).
Lap Pointer
The lap pointer is marked on the v Mode Disk. Whenever you press B to perform
lap time measurement in the Stopwatch Mode, the v Mode Disk will rotate so the
lap pointer points at the current lap number (1 through 5). If the current lap number is
greater than 5, the lap pointer will point at
.
E-39
Advertisement
Table of Contents
