Advertisement
14
electrolux.com.au
TROUBLESHOOTING
Problem
The residual heat
indicator does not
comes on.
The Automatic Heat
Up function does not
operate.
The heat setting
changes between two
levels.
The sensor fields
become hot.
comes on
comes on
and a number
comes on.
comes on
WARNING
WARNING
Repairs to the appliance are only to be carried
out by qualified service engineers. Considerable
danger to the user may result from improper
repairs.
TIPS & INFORMATION
IMPORTANT
If the appliance has been wrongly operated, the
visit from the customer service technician or
dealer may not take place free of charge, even
during the warranty period.
(CONTINUED)
Possible cause and remedy
The cooking zone is not hot because it
operated only for a short time.
There is still residual heat on the
cooking zone.
The highest heat setting is set.
The Power management is activated.
The cookware is too large or you out it too
near to the controls.
The Automatic Switch Off operates.
No cookware on the cooking zone.
Not correct cookware.
The diameter of the bottom of the cookware
is too small for the cooking zone.
There is an error in the appliance.
There is an error in the appliance, because
either the cookware boils dry or you've
used incorrect cookware. Overheating
protection for cooking zone operates.
The automatic switch-off operates.
Remedy
If the cooking zone should be hot, speak to the
service centre.
Let the cooking zone become
sufficiently cool.
The highest heat setting has the same power
as the Automatic Heat Up function.
See the section Power management.
Put large cookware on the rear cooking zones
if it is necessary.
Deactivate the appliance and activate it again.
Put cookware on the cooking zone.
Use the correct cookware.
Move cookware to a smaller cooking zone.
Disconnect the appliance from the electrical
supply for some time. Disconnect the fuse
from the electrical system of the house.
Connect again. If
comes on again, speak
to the service centre.
Deactivate the appliance. Remove the
hot cookware. After approximately 30
seconds, activate the cooking zone again.
If the cookware was the problem, the error
message goes out of the display, but the
residual heat indicator can stay. Let the
cookware become sufficiently cool and refer
to "Cookware for the induction cooking zone"
to see if your cookware is compatible with the
appliance.
Advertisement
