Table of Contents
Advertisement
Other operations
To
Tune in a station
with a weak signal
Stop scanning
during automatic
tuning
Cancel presetting
To improve tuner reception
When tuner reception is poor, set the CD power
manage function to "CD POWER OFF". The
default setting is "CD POWER ON".
Use buttons on the unit for the operation.
1
Press CD.
2
Press ?/1 to turn off the system.
3
Press ?/1 while holding x.
The system turns on automatically. "CD
POWER OFF" appears in the display.
To set to "CD POWER ON"
Repeat the procedure above and "CD POWER
ON" appears in the display.
Notes
• When "CD POWER OFF" is selected, disc access
time is increased.
• You cannot change the CD power manage function
setting in the Power Saving Mode (page 23).
14
GB
Do this
Follow the procedure described
in "Manual tuning preset" on
page 13.
Press x.
Press TUNER MEMORY.
To change the AM tuning interval
Use buttons on the unit for the operation.
The factory settings for AM tuning interval is
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, select any AM station first,
then turn off the system. While holding down
ILLUMINATION, press ?/1. The system turns
on automatically and "AM 10K STEP" or
"AM 9K STEP" appears in the display. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode (page 23).
Tips
• The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
• If you press TUNER/BAND while the system is
turned off, the system turns on automatically and
"TUNER" is selected as the function.
• You can also press FUNCTION on the remote
repeatedly to select "TUNER".
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Before tuning to preset stations, be sure to preset
them (see "Presetting radio stations" on
page 13).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press TUNING MODE on the remote
repeatedly until "PRESET" lights up in
the display.
Advertisement
Table of Contents
