Standard Installation - Tripp Lite U457-1M2-NVMEG2 Owner's Manual

Standard Installation

Notes:
• HDD/SSD drives are sensitive to static electricity and must
be handled properly to prevent the risk of data loss. Always
handle your HDD/SSD drive with caution by wearing an anti-
static strap (such as Tripp Lite's P999-000) when transporting
it or by touching a grounded metal surface to discharge
yourself of static electricity prior to picking up the drive.
• When disconnecting the drive, make sure to go through
the proper disconnection steps of your operating system.
Removing the drive with proper disconnection can result in
data loss or corruption.
1. Using the included mini-screwdriver, remove the two
screws located on either side of the USB-C port.
2. Remove the USB-C cover plate and slide out the
PCBA board.
3. Place your SSD next to the M.2 NVMe M-Key
connector, matching up the mounting holes.
Position the included nut underneath the mounting
hole that matches the length of your SSD.
3