Checking For Gas Leaks - Weber SPIRIT E-210 CLASSIC Owner's Manual

m DANGER
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for
leaks. Sparks or open flames will result
in a fire or explosion, which can cause
serious bodily injury or death and damage
to property.
m WARNING: The gas connections of your
gas grill have been factory-tested.
We do, however, recommend that you
leak-check all gas connections before
operating your gas grill.
m WARNING: Perform these leak checks
even if your grill was dealer- or store-
assembled.
m WARNING: You should check for gas
leaks every time you disconnect and
reconnect a gas fitting.
NOTE: All factory-made connections have been thoroughly
checked for gas leaks and the burners have been flame-
tested. As a safety precaution, however, you should check all
fittings for leaks before using your gas grill. Shipping and
handling may loosen or damage a gas fitting.

CHECKING FOR GAS LEAKS

You will need: A spray bottle or brush or rag and a soap-
and-water solution. (You can make your own soap-and-
water solution by mixing 20% liquid soap with 80% water;
or, you can purchase solution in the plumbing section of
any hardware store.)
A) Turn gas supply on at source.
m WARNING: Do not ignite burners when
leak-checking
Identify your regulator type. Follow the instructions
for that regulator.
Turn Valve
Turn cylinder valve anti-clockwise (1) (2) (3).
Move Lever
Move regulator lever to the on position (4) (5) (6).
PREPARING TO USE YOUR GRILL
1
2
3
5
4
6
15
WWW.WEBER.COM