Sennheiser A 5000-CP - Polarized Antenna for the UHF Band Manual

Sennheiser A 5000-CP - Polarized Antenna for the UHF Band Manual

Also See for A 5000-CP:

Advertisement

Sennheiser A 5000-CP - Polarized Antenna for the UHF Band Manual

Important safety instructions

  1. Read these safety instructions and the instruction manual of the product.
  2. Keep these safety instructions and the instruction manual of the product. Always include all instructions when passing the product on to third parties.
  3. Always include this instruction manual and the safety guide when passing the product on to third parties.
  4. Only use attachments, accessories and spare parts specified by the manufacturer.
  5. Do not attempt to open the product housing on your own. The warranty is voided for products opened by the customer.
  6. Refer all servicing to qualified service personnel. Servicing is required when the product has been damaged in any way, liquid has been spilled or objects have fallen into the product, when the product has been exposed to rain or moisture, does not operate normally, or has been dropped.
  7. Use the product only under the conditions of use listed in the specifications.
  8. Do not operate the product if it was damaged during transportation.
  9. Always run cables so that no one can trip over them.
  10. Keep the product and its connections away from liquids and electrically conductive objects that are not necessary for operating the product.
  11. Do not use any solvents or aggressive cleaning agents to clean the product.

  12. Very high signal levels can damage your hearing and your loudspeakers. Reduce the volume on the connected audio devices before switching on the product; this will also help prevent acoustic feedback.

Intended use

The product is designed for indoor and outdoor use.

The product can be used for commercial purposes.

It is considered improper use when the product is used for any application not named in the corresponding instruction manual.

Sennheiser does not accept liability for damage arising from improper use or misuse of this product and its attachments/ accessories.

Before putting the products into operation, please observe the respective country-specific regulations!

Safety instructions for antennas

Use safety wires to protect the antennas against tipping/ dropping.

The safety wires, rope terminations and coupling links must comply in their dimensioning and condition with the regulations and standards of the country in which they are used!

SPECIFICATIONS

Frequency range 450 – 970 MHz
Radiation pattern Circular polarized helical
Forward gain min 8 dBi (@650 MHz)
Polarization Circular
Connector type N (female), type N-male to BNC-female adapter (included)
Half power beam width ± 40°
SWR <1.5:1
Power handling capability 50 W
Radome depth 5.5" (140 mm)
Ground plate diameter 14" (356 mm) 6061 Anodized Aluminum
Mounting bracket 4 x 3.625 x 3/8" (101 x 93 x 9.5 mm)
Lexan plate, 3/8 Helicoil
Matthews pin avail. for lightning grid mount
Radome material black acrylic
Element Copper
Element support Lexan
Hardware Stainless steel
Approx. weight 3.1 lbs. (1.41 kg)

Pick-up pattern

Pick-up pattern

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Sennheiser A 5000-CP - Polarized Antenna for the UHF Band Manual

Advertisement

Need Assistance?

Do you have a question about the A 5000-CP that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents