4
Connect the plug of the AC power cord to an AC
outlet.
To remove the AC power cord
Press the
switch to the
the standby state, then remove the AC power cord from
the AC power plug holder by holding the fixing levers of
the holder from both sides to release the lock.
18
Removing the Connector Cover
side and switch the unit to
Removing the Connector
Cover
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
power cord.
1
Loosen the two screws.
2
Slide the connector cover in the direction of the
arrow and remove it.
3
Remove the two screws and cable clamp.
Do not remove screws other than the two screws
fixing the clamp. Doing so may cause electric shock.
LMD-X310S
Clamp