Panasonic KX-NS300 Getting Started page 52

4.3.2 Registering IP Telephones
2.
Enter an extension number.
Note
When no extension number is entered in this step, the process will time out and the IP-PT will be
registered without an extension number.
3.
Press [ENTER] on the IP-PT.
4.
Press [PAUSE] or "EXIT" on the IP-PT.
For KX-UT Series SIP Phones
If networking settings have been completed, when KX-UT series SIP phones are connected to the same
network as the PBX, they will be registered automatically as same as when they are registered in Full Automatic
mode. No registration procedure is required.
Note
•
No more than 64 IP-PTs can register extension numbers at the same time.
•
If an extension number that is input for an IP-PT has already been set to another extension, registration
by this mode will fail.
Note that some extension numbers are pre-configured to other extensions by default. Avoid using such
numbers, or delete them before starting the registration process.
Manual Mode
For IP-PTs or KX-UT Series SIP Phones
After connecting IP-PTs or KX-UT series SIP phones to the PBX over a network, register those IP terminals
to the PBX manually.
Follow the procedure below for registration.
To register the IP-PT or KX-UT series SIP phone by entering the MAC address directly:
52 Getting Started
Click Setup ® PBX Configuration ®
1. a.
Configuration ® Slot.
b.
Place the mouse cursor over the Virtual Slot, and
in the menu that appears, click Select Shelf.
c.
For IP-PTs:
Move the mouse pointer over the V-IPEXT8 card
(Virtual 8-Channel VoIP Extension Card).
For KX-UT series SIP phones:
Move the mouse pointer over theV-IPEXT8 card
(Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property.