Panasonic KX-NS300 Getting Started page 44

4.3.1 Assigning IP Addressing Information
Note
•
For KX-NT511 users
For details about operating the PROGRAM button and other buttons, refer to "For IP-PTs" in
"4.3.1 Assigning IP Addressing Information".
•
To confirm the connection to the secondary PBX after assigning IP addressing information, (1) turn
the IP-PT's power off, and (2) hold the STORE button and 2 key while turning the power on.
KX-NT265 (Software version 2.00 or later only)
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
VOL
Press VOLUME to
select "Network".
IP Address*
To set the subnet mask address
VOL
Press VOLUME to
select "Subnet Mask".
To set the default gateway address (if required)
VOL
Press VOLUME to
select "Default GW".
To end programming
Press HOLD to return
to the Menu screen.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
•
Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-PT is on
a remote office LAN
All of the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
44 Getting Started
Press PROGRAM
while "Searching" is displayed.
Press SP-PHONE.
1
Press SP-PHONE.
Press SP-PHONE.
Press SP-PHONE.
HOLD
Press STORE.
PROG.
VOL
Press VOLUME to
select "DHCP (Disable)".
Subnet Mask Address*
Default Gateway Address*
The IP-PT will reboot
and can then be
registered to the PBX.
Press SP-PHONE
twice.
2
Press SP-PHONE.
3
Press SP-PHONE.