XP LC6281/6285 EVA English 01-08-2003 17:52 Pagina 37
MENU
MENU
OK
OK
VOLUME +
VOLUME +
PICTURE SIZE –
PICTURE SIZE +
PICTURE SIZE –
PICTURE SIZE +
VOLUME –
VOLUME –
SOURCE
SOURCE
Lamp Replacement
STANDBY/ON
B
B
B
Philips Home Cinema Projector
6. Maintenance
Lamp
When operation time reaches the last 100 hours of the average lamplife, the message 'Warning:
lamplife has almost expired' will be displayed on the screen, each time the projector is switched
on.
The lamplife remaining can be checked using the OSD menu.
1
Press Menu.
STAND BY
PICTURE FORMAT
AV MUTE
–
The menu bar appears on the screen.
SMART PICTURE
FREEZE
PICTURE SIZE
MIRROR
ZOOM
COMPONENT
S-VIDEO
VIDEO
Use Cursor Control to select Lamp counter in the 'Set up' menu.
2
MULTIMEDIA
CHILD LOCK
INFO
MENU
OK
KEYSTONE
MUTE
–
The used lamplife hours are displayed.
–
When the lamplife has expired, the message 'Warning: lamplife has expired' is displayed on
the screen.
Switch off the projector and wait until the lamp has cooled down (about 5 minutes) before
1
disconnecting the projector. Remove the mains lead from both projector and wall socket.
The mains lead must be disconnected from the projector otherwise the lamp door
cannot be removed.
2
Turn the projector over. Never place the projector on the side where the connections are
located!
Remove the lamp door.
3
–
When tab A is pressed the mains inlet socket will be partly closed. The lamp door therefore
cannot be removed if the mains lead is not disconnected from the projector.
4
Read the caution and warning labels on the lamp holder.
Unscrew screws B.
5
6
Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.
•
Do not tilt. If the inner tube is broken glass particles may fall out.
Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening
•
at anyone.
Carefully remove the new lamp housing from its package.
7
Always use the same type of lamp: LCA3122/00 (150 W), 12nc: 8670 931 22009.
•
Do not touch lamp or point lamp housing opening at anyone.
•
•
Do not drop, as the impact may cause the lamp to break.
Place the lamp holder in the guiding slots and insert into the lamp compartment.
8
37
English User guide LC 6281 / LC 6285
>