Lamp; Lamp Replacement - Philips LC313199 User Manual

Lamp

AV
AV
Source Source Menu Menu
Mute Mute
Lamp Lamp
Stand Stand
by by
Temp Temp

Lamp Replacement

AV AV
Source Source Menu Menu
Mute Mute
Lamp Lamp
Stand Stand
by by
Temp Temp
A
Philips Multimedia Projector
6. Maintenance
When operation time reaches the last 100 hours of the average lamplife, the message 'Warning:
lamplife has almost expired' will be displayed on the screen, each time the projector is switched
on.The lamp indicator lights up orange.
The lamplife remaining can be checked using the OSD menu.
1 Press Menu.
OK OK
– The menu bar appears on the screen.
2 Use Cursor Control to move the cursor to 'Settings'.
3 Use Cursor Control to select 'Lamp counter'.
– The remaining lamplife hours are displayed in the action window at the bottom of the
screen.
– When the lamplife has expired, the lamp indicator lights up red and the message
'Warning: lamplife has expired' is displayed on the screen.
1 Switch off the projector and wait until the lamp has cooled down (about 5 minutes) before
disconnecting the projector. Remove the mains lead from both projector and wall socket.
OK OK
The mains lead must be disconnected from the projector otherwise the lamp door
cannot be removed.
2 Turn the projector over. Never place the projector on the side where the connections are
located!
3 Push tab A to the right and remove the lamp door.
– When tab A is pressed the mains inlet socket will be partly closed. The lamp door therefore
cannot be removed if the mains lead is not disconnected from the projector.
4 Read the caution and warning labels on the lamp holder.
29
English User guide bSure1 / bSure 2
>