Table of Contents
Advertisement
Installation Procedure
1
Place the LG dryer on the LG washing machine.
2
Remove the two screws from the bottom of the rear
cover on each side as illustrated below.
3
Align the stacking kit holes and the rear cover
holes.
3-1) 23.6 inch (600 mm)
3-2) 21.7 inch (550 mm)
4
Fasten the two screws that were removed earlier
from the dryer to the stacking kit.
5
Use the four screws in the accessory box [0.6 inch
(16 mm)] to assemble the washing machine rear
cover and stacking kit.
6
The procedure for the opposite side will be the
same.
10
WARNING
• Incorrect installation can cause serious accidents.
• The weight of the appliance and the height of
installation make the stacking procedure too
risky for one person. This procedure should
be performed by two or more qualified service
personnel.
• The appliance is not suitable for a built-in
installation. Please do not install as a built-in
appliance.
• Do not operate if the appliance is not properly
stacked.
Condensed Water Drain-out
Normally, condensed water is pumped up to the water
container where water is collected until manually
emptied. Water can also be drained out directly to a
mains drain, especially when the dryer is stacked on
top of a washing machine. With a connecting kit for the
mains drain hose, simply change the water path and re-
route to the drainage facility as below:
1
Take the connecting kit out.
2
Separate the water container hose from the kit.
3
Connect the drain hose to the kit.
Advertisement
Table of Contents
