Maintenance - Toro Power Shovel 38361 Operator's Manual

Maintenance

WARNING
If an extension cord is plugged into the appliance,
someone could accidentally operate it while you
are performing maintenance on it, causing serious
personal injury.
Disconnect the extension cord before you perform any
maintenance.
Replacing the Rotor
1. Use a 9/16-inch wrench to remove the bolt on the side of
the housing.
2. Remove the old rotor from the housing.
3. Install the new rotor in the housing by inserting the end of
the rotor onto the fitted end in the housing and rotating the
rotor until it snaps into position.
Figure 7
Figure 8
Figure 9
Note:
The housing will flex when you install the rotor.
4. Tighten the bolt on the side of the housing.
Lubricating the Power
Shovel ™
The Power Shovel
lubricated at the factory for the life of the appliance.
Service
g001333
To best protect your investment and maintain optimal performance
of your Toro equipment, count on Toro genuine parts. When it
comes to reliability, Toro delivers replacement parts designed to
the exact engineering specifications of our equipment. For peace
of mind, insist on Toro genuine parts.
Double-insulated
Appliances
In a double-insulated appliance, two systems of insulation
are provided instead of grounding. No grounding means is
provided on a double-insulated appliance, nor should a means for
grounding be added to the appliance. Servicing a double-insulated
appliance requires extreme care and knowledge of the system,
g001334
and should be done only by the qualified service personnel
at your Authorized Service Dealer. Replacement parts for a
double-insulated appliance must be identical to the parts they
replace. A double-insulated appliance is marked with the words
"Double Insulation" or "Double Insulated." The symbol (square
within a square)
Product Information
A model and serial number decal is located on the housing.
Always refer to specific numbers on the decal in correspondence
or when you need replacement parts.
g001344
6
Figure 10
™ does not need lubrication; all bearings are
may also be marked on the appliance.
g001333