Toro Power Shovel 38310 Operator's Manual

Toro Power Shovel 38310 Operator's Manual

Hide thumbs Also See for Power Shovel 38310:

Advertisement

Important Safety Instructions

To assure maximum safety, best performance, and to gain knowledge of the product, it is essential
that you or any other operator of the Power Shovel read and understand the contents of this manual
before starting the motor. Pay particular attention to the safety alert symbol
CAUTION, WARNING, OR DANGER — "personal safety instruction." Read and understand the
instruction because it has to do with safety. Failure to comply with instruction may result in personal
injury.
IMPORTANT: Save these instructions for future reference

Before Operating

Read and understand the contents of this manual
before operating the Power Shovel. Become familiar
with all controls, and know how to stop the Power
Shovel quickly.
Keep everyone, especially children and pets, away
from the area of operation. Never allow children to
operate the Power Shovel.
Inspect the area thoroughly where you will use the
Power Shovel. Remove doormats, sleds, boards, sticks,
wire, and other foreign objects that the Power Shovel
might pick up and throw. Never direct the discharge
toward people.
Keep all shields and safety devices in place. Repair or
replace any illegible or damaged shield, safety device,
or decal. Tighten any loose nuts, bolts, or screws.
Wear adequate winter clothing and rubber boots to
ensure secure footing on slippery surfaces. Do not
wear loose-fitting clothing that can catch in moving
parts.
Use the Power Shovel on gravel or crushed rock
surfaces only according to the instructions in
Operating on page 6.
WARNING—To prevent electric shock, use only
a UL-approved extension cord suitable for outdoor use
in cold temperatures (16-gauge minimum). Promptly
replace a damaged extension cord.
WARNING
To reduce the risk of electric shock, the Power Shovel
has a polarized plug (one blade is wider than the other)
(Fig. 6) that requires a polarized extension cord. The
appliance plug fits into a polarized extension cord only
one way. If the plug does not fit properly into the
extension cord, reverse the plug. If the plug still does
not fit, obtain a correct polarized extension cord. A
polarized extension cord requires the use of a polarized
wall outlet. This plug fits into the polarized wall outlet
only one way. If the plug does not fit fully into the
wall outlet, reverse the plug. If the plug still does not
fit, contact a qualified electrician to install the proper
wall outlet. Do not change the equipment plug, the
extension cord receptacle, or the extension cord plug
in any way.
To prevent the Power Shovel cord from disconnecting
from the extension cord during operation, tie the
extension cord to the lower handle before connecting
to the Power Shovel cord; refer to Figure 7.

While Operating

Never operate the Power Shovel near people, pets,
glass enclosures, automobiles, trucks, window wells,
or a drop-off without properly adjusting the snow
discharge angle; refer to Operating Tips on page 5.
Avoid accidental starting. Do not insert the key until
after plugging in the Power Shovel. Remove the key
before carrying the Power Shovel when plugged in.
If the Power Shovel cord is damaged, pull the
extension cord from the wall receptacle and replace
the cord.
which means

Advertisement

Table of Contents
loading

Summary of Contents for Toro Power Shovel 38310

  • Page 1: Important Safety Instructions

    Important Safety Instructions WARNING To assure maximum safety, best performance, and to gain knowledge of the product, it is essential that you or any other operator of the Power Shovel read and understand the contents of this manual before starting the motor. Pay particular attention to the safety alert symbol which means CAUTION, WARNING, OR DANGER —...
  • Page 2 If major repairs are needed, contact concealed, moving, or rotating parts. your local Authorized Service Dealer or the Toro Service Center for assistance. Clear the snow from slopes by going up and down, never across the face.
  • Page 3 Assembly 4. Secure the upper and lower tubes by inserting the countersunk nut and the slotted screw (supplied in loose parts bag) through the aligned holes in the tubing (Fig. 3). POTENTIAL HAZARD Internal wiring could be damaged during shipping or assembly. WHAT CAN HAPPEN Damaged wiring could cause serious personal injury when operating the snowthrower.
  • Page 4 4. Push the connectors into the motor housing hole. 5. Make sure the handle support is positioned as shown in Figure 5B (the Toro Power Shovel decal should be facing up). Slide the handle support over the power head. Make sure the grooves in the handle support and power head are interlocked (Fig.
  • Page 5: Operation

    Operation Preparing the Snowthrower For safe and efficient use of your Power Shovel, use only a UL-listed extension cord recommended for outdoor use. Refer to the Extension Cord Chart below. Extension Cord Chart 1. Tie the extension cord to the lower handle of the If length of extension cord is 100 ft.
  • Page 6: Maintenance

    Starting and Stopping Remove the key and disconnect the extension cord after using the Power Shovel. Hang the Power Shovel on a nail from the hole in the rear of the control grip. To start the Power Shovel, install the key and squeeze the Hang the extension cord with the Power Shovel so it switch bar.
  • Page 7: Toro Service Support

    Toro Service Support If your unit requires service or maintenance, your nearest Toro Master Service Dealer is the best dealer to assist you. Refer to the “Yellow Pages” of your local telephone directory in the section titled “Lawn Mowers.” Toro Master Service Dealers are listed under the Toro trademark.
  • Page 8 Rev. 3/22/99...

Table of Contents