Table of Contents
Advertisement
Heat generated by the device is channeled outwards from the enclosure. As such, it
is recommended that 2.5 cm (1 in) of space be maintained on all open sides of the
device to allow for some convectional airflow.
Forced airflow is not required. However, any increase in airflow will result in a
reduction of ambient temperature and improve the long-term reliability of all
equipment mounted in the rack space.
Note
For detailed dimensions of the device with either DIN rail or panel hardware installed,
refer to
2.3.1
Mounting the Device on a DIN Rail
The RUGGEDCOM RMC8388 can be ordered with a DIN rail adapter preinstalled on
the back of the chassis. Use the adapter to mount the device to a standard 35 mm
(1.4 in) IEC/EN 60715 or TS35 DIN rail.
To mount the device to a DIN rail, do the following:
Mounting the Device
To mount the device to a DIN rail, do the following:
1.
RUGGEDCOM RMC8388
Installation Manual, 11/2022, C79000-G8976-1188-05
NOTICE
"Dimension Drawings" (Page
Hook the top teeth of the adapter onto the DIN rail.
Note
The adapter features a sliding release with a slot at the bottom for a flathead
screwdriver.
2.3.1 Mounting the Device on a DIN Rail
27).
Installing the Device
11
Advertisement
Table of Contents
