Table of Contents
Advertisement
Assembly
Loose Parts
Note:
Use the chart below to verify that all parts have been shipped.
DESCRIPTION
Traction Unit
Valve Lever
Key
Hydraulic oil filter
Installing the Valve Lever
1.
Thread the lever into the speed selector valve
(Fig. 1).
Note:
The lever should be installed with the
bend toward the operator.
2.
Tighten the jam nut on the lever to lock it in
position.
1
Figure 1
1. Speed selector lever
8
QTY.
1
Install valve lever
1
2
Start engine
1
Break-in oil change
Activating the Battery
The traction unit is shipped with a dry battery. Bulk
electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet.
1.
Remove the hood; refer to Removing the Hood,
page 26.
2.
Remove the wing nuts and bar securing the
battery (Fig. 2).
m–3883
1. Battery
2. Bar
3. Positive cable
USE
3
4
Figure 2
4. Rubber cover
5. Negative cable
5
2
1
m–4391
Advertisement
Table of Contents
